Typical “don’t sue me” stuff applies, here.
A friend of mine sent me his broken gofers and some non-painted reproductions. I used the facial details from the broken original with the structural benefits of the reproduction to create a couple models for 3d printing replacements. You can grab the models for your personal use and printing, here:
https://www.dropbox.com/sh/06tmsbnqvcm2ncz/AAD-tWBVPFfBnVCCPDQoOioJa?dl=0
I’m not interested in doing this for cash but if you are desperate, need a set - I’m happy to help you out as a favor, just email me.
I also found this thread on Pinside, recommend you reach out - their results look many times better than my scans :)
PLA Print w/ PLA Supports - these turned out pretty good
PETG Print w/ PETG supports. The PETG support boogers are too difficult to remove to be practical.
PETG Prints w/ PVA SUpports
The results are good pre-painted, extremely tough. The print layer lines are obvious, in this batch.